Hioki IM7580, Instruction Manual

Page: 135 / 340

127
Equivalent Circuit Analysis Function
(3) Setting the frequency range for analyses
This section describes how to set the frequency range used to perform equivalent circuit analysis
when using normal sweep. This function allows you to restrict local extreme values to be used for
the analysis in case several local extreme values exist in the sweep range. Configures the setting
so that local extreme values are included in the analysis range. This setting is valid only during
normal sweep operation.
1
2
3
1
Press [SETUP] .
2
Press [CIRCUIT] tab.
3
Press [AREA] .
4
5
6
Changing the unit: M (mega)/ k (kilo)
4
Press [START] , use the numeric keypad to enter
the frequency at which to start analysis, and press
[Hz] .
Settable range 1.0000 MHz to 300.00 MHz
[C] Repeats the input.
[CANCEL]
Closes the window without setting the
analysis range.
[RESET]
Resets the analysis range that has been
set.
5
Press [STOP] , use the numeric keypad to enter the
frequency at which to end analysis, and press [Hz] .
Settable range 1.0000 MHz to 300.00 MHz
6
Press [SET] to accept the frequency range.
The accuracy of the analysis may deteriorate if a very narrow frequency range is set.
4
Analyzer Function