Hioki IM7580, Instruction Manual

Page: 134 / 340

126
Equivalent Circuit Analysis Function
(2) Setting the analysis method
This section describes how to set whether to perform equivalent circuit analysis automatically after
measurement completes or to wait until [RUN] is pressed.
1
2
3
4
1
Press [SETUP] .
2
Press [CIRCUIT] tab.
3
Press [MANU/AUTO] .
4
Selects the analysis method .
[MANUAL] Press
[RUN] to perform analysis.
[AUTO]
Analysis is automatically performed after
completion of measurement.
5
Press [EXIT] to close the setting screen.
Equivalent circuit analysis cannot be performed with
[MANUAL]
in the continuous measurement
screen. To perform equivalent circuit analysis during continuous measurement, change the
setting to
[AUTO]
and save the panel.
Refer to “4.2.2 Starting Measurement at Any Arbitrary Timing (Trigger)” (p. 70)