33
Chapter 4 Instrument Functionality
索引
4
3
2
1
7
6
5
10
9
8
The buzzer is configured when turning on the instrument.
Turning off the buzzer:
Turn on the instrument by pressing the
[POWER]
key while holding down the
[AVG]
key to disable the buzzer.
Re-enabling the buzzer:
Turn on the instrument by pressing the
[POWER]
key while holding down the
[AVG]
key again to re-enable the buzzer.
The display backlight remains on at all times and cannot be
turned off.
The Auto Power Save function is configured when turning on the
instrument.
• The function operates automatically when the instrument is
turned on.
• After five minutes of inactivity and no measurement signal
detection, the instrument turns off automatically. This function
is only operative when using battery power.
• "APS" starts to blink at 30 seconds before turning off.
Disabling Auto Power Save: :
Turn on the instrument by pressing the
[POWER]
key while holding down the
[HOLD]
key to disable
Auto Power Save.
Re-enabling Auto Power Save:
Turn off the instrument and then turn it back on.
The APS function will be enabled.
Configuring the Buzzer
Display Backlight
Auto Power Save (APS) Function
Buzzer disabled
Buzzer enabled
APS enabled
APS disabled
