Hioki 8910, Instruction Manual

Page: 87 / 150

79
7.3 Massage ID Trigger
• The message ID trigger outputs a pulse ( H active) with a width of
100
μ
s from the logic channel selected when a specified ID
message is input.
• This is effective when using this instrument in combination with a
recorder with a trigger function.
7.3.1 Setting the message ID trigger
[ ID_TRIGGER ] located at the left-upper corner of the window is used
to set the message ID trigger.
Checking the check box enables the trigger function.
When the trigger function is turned on, the no. of the message ID for
triggering signal output must be entered in the [
M_ID ] input box.
7.3 Massage ID Trigger
Analog/logic output is held until the next CAN message is converted.
Therefore, setting the ID trigger does not allow you to observe the output
pulse even when a logic output is held H. In such case, turn off the power of
the 8910, then turn it back on and set the logic output to L before setting the
ID trigger.
1
Check the [ID_TRIGGER] box.
2
Input the massage ID number.
Example : Entering message ID100 outputs a signal from the logic
channel selected.
Deselecting the [ ID_TRIGGER ] check box deactivates the
message ID trigger function.
If communication with the 8910 is performed with the [
ID_TRIGGER
]
check box selected, but with no number entered in the [
M_ID
] input box, a
transmission error occurs and communication will be aborted.