Hioki 8910, Instruction Manual

Page: 65 / 150

57
6.2 Editing the CAN Definition Data
6.2.6 Setting the signal name
A signal name with up to 40 characters can be assigned to data.
• Click the signal name input box, then enter a signal name.
• The signal name is useful for identifying data among other data
used in the condition setting program. A comment can be entered
as the signal name.
• When the 8910 CAN ADAPTER is used with the HIOKI 8826, 8841,
8842 MEMORY HiCORDER, the signal name can be transferred to
the 8826, 8841, 8842 MEMORY HiCORDER as comment data.
6.2.7 Setting the label name
The label name must be set for each item of data since data is
distinguished by the label name on the 8910.
• Make sure that the same label name is not used twice.
• Up to 16 characters can be used in the label name.
To enter a label
name, click the label name input box, then enter a name.
6.2.8 Setting the unit
Data can be attached with a unit of physical quantity with up to 8
characters.
• Click the unit input box, then enter a unit.
Spaces or commas cannot be used in a signal name.
Spaces or commas cannot be used in a label name.
Spaces or commas cannot be used in an unit.