Hioki 3504-40 C HiTester, Instruction Manual

Page: 114 / 292

6.8 Load the Measurement Conditions (Panel Load Function)
108
The saved measurement values and compensation values can be loaded from
internal memory.
First, set the load condition.
There are the following three load conditions.
•
All
The measurement conditions (frequency, level, range, upper limit and lower
limit values, etc.) and the open circuit, short circuit, load circuit, and offset
compensation values.
• Compensation values
The open circuit, short circuit, load circuit, offset compensation values and self
calibration setting.
• Measurement conditions
The measurement conditions (frequency, level, range, upper limit and lower
limit values, etc.).
1.
Press .
The upper part of the MAIN display area displays the menu contents and the
lower part displays the setting information.
(Refer to "Menu display organization" (p. 13) for menu order)
2.
Use or to select the “Ld_tYP” menu item.
3.
Use and to select a setting item.
Pressing or causes the display to change in the following manner.
6.8 Load the Measurement Conditions
(Panel Load Function)
(Load condition setting screen)
Menu content
Judgment mode
(set in step 3)
(MAIN display area)
“ALL”
Loads the measurement conditions (frequency, level,
range, upper limit and lower limit values, etc.) and the
open circuit, short circuit, and load compensation values.
“hArd”
Loads the measurement conditions (frequency, level,
range, upper limit and lower limit values, etc.).
“Corr”
Loads the open circuit, short circuit, and load compensa-
tion values.