Hioki 2300 Smart Site, Instruction Manual, Page: 324 / 366

19 2391-01, 2391-02, 2391-03 MODULE BASE
311
11
12
13
14
15
16
17
18
19
APPX
IDX
20
19.2.1 Installing the Module
(1) Installing the Module Base
Fasten the module base securely using either method below.
Mounting the Module Base on a DIN Rail
Use the DIN rail mount connector on the rear of the base to mount
the module base on a DIN rail (35 mm wide).
The side of the module base with square holes is the bottom.
Hang the top hook of the DIN rail mount connector on the DIN rail,
then push down the bottom of the server.
Removing the Module Base
Remove the module base from the DIN rail, while using a flat blade
screwdriver to push down the orange lever at the bottom of the
connector.
Use the module base for screwdriver leverage.
19.2 Preparations
• Do not mount the module base on the ceiling where it may fall off.
• The module base shall be fastened using the proper means.
If the module base slides right and left due to tolerances of the
DIN rail dimensions, modules may fall off, wires may be short-
circuited, or circuits broken.