Hioki 2300 Smart Site, Instruction Manual, Page: 316 / 366

18 2362-20 DC POWER MODULE
303
11
12
13
14
15
16
17
18
19
APPX
IDX
20
18.3.1 Basic Specifications
18.3.2 Function Specifications
18.3.3 General Specifications
18.3 Specifications
Operation Supplies power to measurement/communications modules.
Rated output voltage 5.0 VDC
Maximum
output current 2.4 A
Maximum output
power 12.0 VA
Output voltage accu-
racy ±5.0% (Within operating temperature and humidity ranges)
Overcurrent protection Min. 105% (Constant current/constant voltage pendent and automatic rest)
Overvoltage protection 110 to 140% (Output shutdown and manual reset)
Input surge current 80 A max at 36 VDC.
Parallel operation Not available
Communication inter-
face Not available
Input terminal Terminal block (Front panel)
Output terminal Internal bus connector
Power switch ON/OFF of output voltage
Rated supply voltage 19 to 36 VDC
Maximum rated power 20 W
Dielectric strength 0.5 kVAC (Between input and output) Response current 5 mA
Fuse The polyswitch is built in (on the + side with trip current of 3.7A).
Dimensions Approx. 45.5W × 96H × 94.5D mm (1.79"W × 3.78"H × 3.72"D)
(Including cover, excluding projections)
Mass Approx. 250 g (8.8 oz.) (Including cover)
Accessories Ferrite clamp............................................................................................................... 1
Operating
temperature and
humidity 0 to 50°C (32 to 122°F), 80%RH or less
(non-condensating)
Storage
temperature and
humidity -10 to 50°C (14 to 122°F), 80%RH or less
(non-condensating)
Operating environment Indoors, altitude up to 2000 m (6562-ft.)
Applicable
standards Safety EN610101
Pollution degree 2
EMC EN61326 CLASS A