FUEL SYSTEM (J05E)
7–28
REPLACEMENT
EN01F02127060402007002
REMOVING THE SUPPLY PUMP
! CAUTION
While working, be careful not to make dirt and water enter parts.
1.
TURNING THE STARTER SWITCH TO THE LOCK POSITION
! CAUTION
Perform the following work after the engine cools off to avoid fire
or burning. The fuel in the common rail could have a high temper-
ature (approximately 100
C {212
F}) immediately after driving.
2.
FUEL DISCHARGE
(1)
Prepare reservoir under the drain plug to receive the drained fuel.
(2)
Loosen the drain plug and then the air bleeding plug of the fuel fil-
ter, and drain the fuel from the drain plug. Check that the fuel is no
longer drained from the drain plug and then tighten the drain plug
with a new O-ring.
Tightening Torque:
5-9 N·m {51-91 kgf·cm, 3.7-6.6 lbf·ft}
! CAUTION
Drain the fuel in accordance with the regulation of disposal speci-
fied in each region.
3.
REMOVING THE FUEL FILTER CASE
(1)
Remove the fuel filter case and the fuel pipe.
4.
DISCONNECTING THE HARNESS
(1)
Disconnect the connector connected to each of the suction con-
trol valve of the supply pump and the fuel temperature sensor.
SHTS021270600058
DRAIN PLUG
PRIMING
PUMP
AIR BLEEDING
PLUG
SHTS021270600059
FUEL
TE
M
PERATURE
SENSOR
SUCTION
CONTROL
V
AL
V
E
SHTS021270600060
