Hino 600, Workshop Manual, Page: 54 / 451

CLUTCH MAIN UNIT (EATON 1401) CL02–7
OVERHAUL
EN02Z0202H200001
IMPORTANT POINT - DISMOUNTING
1. REMOVE THE TRANSMISSION, SUPPORTING ITS WEIGHT TO
PREVENT DAMAGE TO THE BEARING AND DISCS.
2. INSTALL TWO WOODEN SPACERS 1"-1-1/2" THICK BETWEEN
RELEASE BEARING AND COVER ASSEMBLY.
3. REMOVE THE CLUTCH FROM THE FLYWHEEL.
IMPORTANT POINT - INSPECTION AND REPLACE-
MENT
1. REPLACE THE PILOT BEARING.
(1) Remove the pilot bearing.
SST:
Pilot Bearing Puller (S0965-01970)
Sliding Hammer (S0942-01442)
(2) Using a suitable tapping rod, install the pilot bearing.
NOTICE
After installing the pilot bearing, ensure that it rotates smoothly.
2. CHECK THE FOLLOWING ITEMS FOR WEAR REPLACE ANY
WORN COMPONENTS:
(1) Cross-shafts and bushings
NOTICE
Excessive wear at these points can cause a side loading condition.
Also, inspect the remaining pivot points of the linkage for excessive
wear.
1.Remove the
transmission
SHTS02Z020200007
SHTS02Z020200008
SHTS02Z020200009
A.
Check cross-shafts
and
bushings
SHTS02Z020200010