GENERAL INTRODUCTION/TROUBLE SHOOTING
1–25
TROUBLE DIAGNOSIS USING THE COMPUTER (HINO DX
Ⅱ
)
STEP OF TROUBLE DIAGNOSIS
EN01H01ZZZ040301003001
1.
PREPARATION FOR CONNECTING HINO DX
Ⅱ
(1)
The "HINO DX
Ⅱ
" is a failure diagnosis tool for the common
rail fuel injection system and the chassis system. For con-
necting the computer to a vehicle, the "DST-i" and the dedi-
cated cable will be required.
SPECIAL TOOL: Computer interface
HINT
Install the "Hino Diagnostic eXplorer
Ⅱ
" (HINO DX
Ⅱ
) software in a
computer. For detailed installation procedures, refer to the HINO
DX
Ⅱ
OPERATION MANUAL supplied on the Global Service Portal
Site (Hino-GSPS).
2.
CONNECTION OF HINO DX
Ⅱ
(1)
Connect the DST-i to the trouble diagnosis connector located
in the electrical component box in the instrument panel or
located in the electrical component box behind the rearmost
seat.
(2)
Connect the computer in which the HINO DX
Ⅱ
is installed, to
the DST-i.
(3)
Turn the starter key to "ON".
(4)
Turn on the power switch of the computer to start the HINO
DX
Ⅱ
.
SHTS01ZZZ0400004
Part name
Part No.
DENSO DST-i Set
(Without LCD)
Without Bluetooth
95171-01021
With Bluetooth
95171-01041
DENSO DST-i Set
(With LCD)
Without Bluetooth
95171-01031
With Bluetooth
95171-01051
Trouble diagnosis connector
SHTS01ZZZ0400005