
WARNING:
To avoid fire, shock and serious personal
injury, follow these instructions:
A. Read your owner's manual carefully, retain owner's
manual for future reference.
B. To avoid possible electrical shock, be sure
electricity is turned off at the fuse box or circuit
breaker panel before wiring.
C. This switch is designed for ceiling fan only, to avoid
overheating and possible damage to other
equipment, do not install to control receptacle,
fluorescent lighting fixture, motor-operated
appliance, transformer-supplied appliance or near
heat source.
D. All wiring must conform to national and local
electrical codes. If you feel you do not have
enough electrical knowledge, have a licensed
electrician install the control.
E. Total amperage and/ or wattage for your fan should
not exceed 120 Volts, 60 HZ, 1.25A (Max.)
1. Turn power OFF at fuse box or circuit breaker and
remove the existing wall plate and switch, do not
remove wires before noting their position. (Figure 1).
2. Make wire connections (Figure 2) and secure with
wire nuts supplied.
● Connect the black wire from the fan to black wire
from the wall control.
● Connect the blue wire from the fan to the blue wire
from the wall control.
● Connect the white (neutral) wire from the ceiling to
the white wire from the fan.
● Connect the black (hot) wire from the ceiling to the
black/white wire from the wall control.
● If your outlet box has a ground wire (green or bare
copper) connect the wall control’s ground wire to
it; otherwise connect the wall control’s ground wire
directly to one of the screws from the outlet box.
3. Attach the control to the outlet (wall) box and secure
with 2 outlet box screws (Figure 3).
4. Attach the wall plate over the wall control and secure
with the two screws provided (Figure 3).
Fig. 1
Fig. 2
Fig. 3
Wall plate
Switch
Outlet box
Hot
Black
Black/
White
Black
Black
White
White
Blue
Blue
Fan
Neutral
120 VAC
60Hz
Green Ground
Green/
Ground
Wall plate
Outlet box
Screws
Screws
Wall control
Wall control
4 SPEED FAN & LIGHT
WALL CONTROL
INSTALLATION INSTRUCTIONS
Model: 980008
READ AND SAVE THESE INSTRUCTIONS
BE SURE TO FOLLOW ALL STEPS IN THE ORDER GIVEN.
BE SURE POWER IS OFF AT FUSE, OR CIRCUIT BREAKER BOX.
For Warranty Information please visit www.hinkley.com
Do Not use control with DC fans