Page
Rev. 3
7
4. While the channel number is flash,it can be changed with
“
UP
”
and
“
DOWN
”
arrow
buttons.The selection can be saved by short pressing ‘’16/9’’ key and the screen display ‘’P’’
icon to indicate that the secondary priority channel has been changed.
5.The user can reprogram the secondary priority channel on the HM130
B.5 Hi/Lo/LOCK Key
Short press Hi/Lo/LOCK key will toggle the TX power from Hi to Lo ,corresponding HI/LO
icon will display on the LCD.
Some of channels has been limited to be low power only or high power only. Thus, the
software needs to check against the channel setting stored in the EEPROM.
If the operation request is denied,error beeps tone will out.
All keypad will be locked except PTT key by pressing Hi/Lo/LOCK key more than 3
seconds, correspondingly the ’’lock icon ’’will display on the LCD,press Hi/Lo/LOCK key again
more than 3 seconds will release the key lock function
B.6 Private Channel
Shore press
CH/*/UIC enter into private channel mode,switch it by press UP/DOWN
key.If private channel didn’t exist,it will display’’--’’ .
B.7 WX Channel(Only available for USA,Canada)
Short press WX/*/UIC key will enter WX mode. Press Up/Down key to change WX channel.
Long press WX/*/UIC key to enable and detect weather alarm,if the alert tone is detected, the
‘’ALT’’ symbol should flash in the screen,long press WX/*/UIC again to cancel weather
alarm,‘’ALT’’ symbol will disappear accordingly.
B.8 UIC Band
Long press CH/*/UIC to switch operational channel band(USA,INT and CAN).When band
was switched,the band sequence will change accordingly.
Noted:If one frequency was programmed to this radio device,activating this function will
generate wrong alarm.
B.9 SCAN
This is the function to scan for broadcasting channels. When available channel detected,
