HIMA HIMax X-DO 12 01, Manual, Page: 22 / 52

3 Product Description X-DO 12 01
Page 22 of 52 HI 801 023 E Rev. 5.00
3.6.2 Terminal Assignment for Connector Boards with Screw Terminals
Pin no. Designation Signal Pin no. Designation Signal
1 01a DO1- 1 02a DO2-
2 01b DO1+ 2 02b DO2+
Pin no. Designation Signal Pin no. Designation Signal
1 03a DO3- 1 04a DO4-
2 03b DO3+ 2 04b DO4+
Pin no. Designation Signal Pin no. Designation Signal
1 05a DO5- 1 06a DO6-
2 05b DO5+ 2 06b DO6+
Pin no. Designation Signal Pin no. Designation Signal
1 07a DO7- 1 08a DO8-
2 07b DO7+ 2 08b DO8+
Pin no. Designation Signal Pin no. Designation Signal
1 09a DO9- 1 10a DO10-
2 09b DO9+ 2 10b DO10+
Pin no. Designation Signal Pin no. Designation Signal
1 11a DO11- 1 12a DO12-
2 11b DO11+ 2 12b DO12+
Table 13: Terminal Assignment for Connector Boards with Screw Terminals
Cable plugs attached to the connector board pin headers are used to connect to the field zone.
The cable plugs feature the following properties:
Connection to the field zone
Cable plugs 12 pieces, with 2 poles
Wire cross-section 0.2…2.5 mm
2
(single-wire)
0.2…1.5 mm
2
(finely stranded)
0.2…1.5 mm
2
(with wire end ferrule)
Stripping length 13 mm
Screwdriver Slotted 0.6 x 3.5 mm
Tightening torque 0.4…0.5 Nm
Table 14: Cable Plug Properties