HIMA HIMatrix, Manual

Page: 5 / 38

AI 8 01 1 Introduction
HI 800 195 E Rev. 2.00 Page 5 of 38
1 Introduction
This manual describes the technical characteristics of the module and its use. It provides
information on how to install, start up and configure the module.
1.1 Structure and Use of this Manual
The content of this manual is part of the hardware description of the HIMatrix programmable
electronic system.
This manual is organized in the following main chapters:
 Introduction
 Safety
 Product Description
 Start-up
 Operation
 Maintenance
 Decommissioning
 Transport
 Disposal
The HIMatrix F60 is available for the programming tools SILworX and ELOP II Factory. Which
programming tool can be used, depends on the processor operating system of the HIMatrix
F60, refer to the following table:
Programming tool Processor operating system Communication operating system
SILworX CPU OS V7 and higher COM OS V12 and higher
ELOP II Factory CPU OS up to V6.x COM OS up to V11.x
Table 1: Programming Tools for HIMatrix F60
In the manual, the differences are specified by using:
 Separated chapters
 Tables differentiating among the versions
i
Projects created with ELOP II Factory cannot be edited with SILworX, and vice versa!
i
The manual usually refers to the plug-in cards of the modular controller F60 as
modules
.
Modules
is also the term used in SILworX.