HIMA HIMatrix F60, Manual

Page: 98 / 114

8 Operation System Manual Modular Systems
Page 98 of 114 HI 800 191 E Rev. 2.02
CPU COM
Number of entries in the long term
diagnosis 1000 200/250
1)
Number of entries in the short term
diagnosis 500 700/800
1)
1)
Higher value for COM operating system version 4 and higher
Table 63: Maximum Number of Entries in the Diagnostic History - up to CPU OS V7
The long-term diagnosis of the processor system includes the following events:

Reboot

Changed mode of operation
(INIT, RUN, STOP/VALID CONFIGURATION, STOP/INVALID CONFIGURATION),

Changed program mode of operation
(START, RUN, ERROR, TEST MODE),

Configuration load or deletion

Configuration and reset of switches

Processor system failures

Operating system download

Forcing (setting and resetting the force switch is allowed)

I/O module diagnostics

Power supply and temperature diagnostics
The long-term diagnosis of the communication system includes the following events:

Reboot of the communication system

Changed mode of operation
(INIT, RUN, STOP/VALID CONFIGURATION, STOP/INVALID CONFIGURATION),

User log-in

Operating system load
If the memory for the long term diagnosis is full, all data older than three days is deleted
allowing new entries to be stored. If no data is older than three days, the new entries cannot be
stored and get lost. A message in the long-term diagnosis warns that it was not possible to store
the data.
The short-term diagnosis of the processor system includes the following events:

Processor system diagnostics (setting the force switches and force values)

User program diagnostics (cyclic operation)

Communication diagnostics

Power supply and temperature diagnostics

I/O module diagnostics
The short-term diagnosis of the communication system includes the following events:

safe ethernet -related events

Start / stop while writing to the flash memory

Faults that can occur while loading a configuration from the flash memory

Unsuccessful time synchronization between the communication system and the processor
system
Parameter errors associated with the inputs or outputs are possibly not detected during the
code generation. If a parameter error occurs, the message INVALID CONFIG with the error