F3 DIO 16/8 01
4 Start-Up
HI 800 177 E Rev. 1.01
Page 39 of 58
4.3.4
Pulsed Outputs for F3 DIO 16/8 01
The following table presents the statuses and parameters for the pulse module (DO 2 01) in
the same order given in the SILworX Hardware Editor.
4.3.4.1
Module
Tab
The
Module
tab contains the following system parameters.
System Signal
Data
type
R/W Description
DO.Error Code
WORD
R
Module error code
Coding
Description
0x0001
Error of the TO unit as a whole:
Module Error Code WORD
R
Module error code
Coding
Description
0x0000
I/O processing, if required with errors, see
other error codes
0x0001
No I/O processing (remote I/O not in RUN)
0x0002
No I/O processing during the booting test
0x0004
Manufacturer interface operating
0x0010
No I/O processing: wrong configuration
0x0020
No I/O processing: fault rate exceeded
0x0040/
0x0080
No I/O processing: configured module not
plugged in
Module SRS
UDINT
R
Slot number (System Rack Slot)
Module Type
UINT
R
Type of module, target value: 0x00D3 [211
dec
]
Table 25: SILworX - System Parameters for Pulsed Outputs,
Module
Tab
4.3.4.2
DO 2 01: Channels
Tab
The
DO 2 01: Channels
tab contains the following system parameters.
System Signal
Data
type
R/W Description
Channel no.
---
R
Channel number, defined by default
-> Error Code [BYTE] WORD
R
Error code of the individual digital pulsed output channels:
Coding
Description
0x01
Fault in the digital output module
Value [BOOL] ->
BOOL
R
Output value for TO channels:
Coding
Description
FALSE Output
de-energized
TRUE Output
energized
Do not use pulsed outputs as safety-related outputs!
Table 26: SILworX - System Parameters for Pulsed Outputs,
Module
Tab
