Hilti SC 70W-A22, Original Operating Instructions

Page: 35 / 228

*2092401*
2092401 English 29
6.1 Cleaning the safety guard
1. Remove the saw blade before cleaning the safety guard parts.
2. Clean the safety guard parts carefully with a dry brush.
3. Use a suitable tool to remove deposits or cuttings from the inside surfaces of the safety guard parts.
4. Fit the saw blade.
6.2 Procedure if the chip / dust channel is blocked
1. Remove the battery.
2. Clean the chip / dust channel.
Remove the saw blade if necessary. → page 26
3. Check for misalignment or binding of moving parts, breakage of parts and any other condition that may
affect operation of the product.
6.3 Checks after cleaning and maintenance
After cleaning or maintenance, check that all safety devices are fitted and that they function faultlessly.
▶
To check the pivoting guard, open the guard fully by moving the guard operating lever.
➥ The pivoting guard must close quickly and completely when the guard operating lever is released.
7 Transport and storage of cordless tools
Transport
CAUTION
Accidental starting during transport !
▶
Always transport your products with the batteries removed!
▶
Remove the battery.
▶
Never transport batteries in bulk form (loose, unprotected).
▶
Check the tool and batteries for damage before use after long periods of transport.
Storage
CAUTION
Accidental damage caused by defective or leaking batteries !
▶
Always store your products with the batteries removed!
▶
Store the tool and batteries in a place that is as cool and dry as possible.
▶
Never store batteries in direct sunlight, on heating units or behind a window pane.
▶
Store the tool and batteries in a place where they cannot be accessed by children or unauthorized
persons.
▶
Check the tool and batteries for damage before use after long periods of storage.
8 Troubleshooting
▶
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
8.1 The circular saw is not in working order
Malfunction Possible cause Action to be taken
The LEDs do not light. The battery is not fully inserted.
▶
Insert the battery.
The battery is discharged.
▶
Charge the battery.
The battery is too hot or too cold.
▶
Bring the battery to the correct
ambient temperature.
Printed: 30.04.2019 | Doc-Nr: PUB / 5206169 / 000 / 03