Hilti NURTON BX 3-22, Manual

Page: 30 / 356

24 English 2268212
*2268212*
▶
If the battery is too hot to touch, it may be defective. Put the battery in a place where it is clearly visible
and where there is no risk of fire, at an adequate distance from flammable materials. Allow the battery to
cool down. If it is still too hot to touch after an hour, the battery is faulty. Consult Hilti Service or read the
document entitled "Instructions on safety and use for Hilti Li-ion batteries".
Observe the special guidelines applicable to the transport, storage and use of lithium-ion batteries.
Read the instructions on safety and use of Hilti Li-ion batteries that you can access by scanning
the QR code at the end of these operating instructions.
3 Description
3.1 Product overview 1
@
Nosepiece
;
Fastener guide
=
Fastener guide locking catch
%
Single-fastener head (BX 3-ME-22)
&
Air vents
(
Eye for tool tether
)
Belt hook
+
Safety trigger
§
Grip
/
Belt hook/scaffold hook
:
Battery release button
∙
Battery status indicator
$
Li­ion battery
£
Installation opening for accessories
|
Nail pusher
¡
Nail pusher release mechanism
Q
Support leg
W
Magazine
E
Status indicator, fastening tool
R
Work-area light
3.1.1 Equipment
The fastener guide and the support leg are product-dependent. The support legs and fastener guides with
which the product is equipped are listed in the table below.
Further information can be found in the case lid, in your Hilti Store or at: www.hilti.group
Product BX 3-22 BX 3-L-22 BX 3-ME-22
Fastener guide X-FG B3 IF 02 X-FG B3 IF 02 X-FG B3 ME
Support leg X-SL B3 03 X-SL B3 03 X-SL B3 ME 03
3.2 Intended use
The product is a hand-held, cordless fastening tool. It is designed to drive specially manufactured fasteners
into concrete, steel, masonry, sand-lime block and other materials suitable for use of the direct fastening
technique. The product is also designed to fasten electrical cables with clips if the appropriate fasteners are
used. Use only approved fasteners in combination with their corresponding fastener guide (see the section
headed "Technical data").
The fastening tool, battery and fasteners together form a technical entity. This means that trouble-free
fastening with this fastening tool can be ensured only when the fasteners specially manufactured for the
purpose by Hilti and the chargers and batteries recommended by Hilti are used. The fastening and
application recommendations made by Hilti apply only when these conditions are observed.
▶
The fastening tool is for hand-held use only.
▶
Misuse must be ruled out. Misuse is understood to include driving fasteners into very soft materials (e.g.
wood) or into excessively hard materials (e.g. high-strength steel or very hard natural stone).