Hilti Nuron DSH 600-22, Original Operating Instructions

Page: 38 / 320

34 English 2284136
*2284136*
8 Transport and storage of cordless tools and batteries
Transport
CAUTION
Accidental starting during transport !
▶
Always transport your products with the batteries removed!
▶
Remove the battery/batteries.
▶
Never transport batteries loose and unprotected. During transport, batteries should be protected from
excessive shock and vibration and isolated from any conductive materials or other batteries that may
come in contact with the terminals and cause a short circuit. Comply with the locally applicable
regulations for transporting batteries.
▶
Do not send batteries through the mail. Consult your shipper for instructions on how to ship undamaged
batteries.
▶
Prior to each use and before and after prolonged transport, check the product and the batteries for
damage.
Storage
WARNING
Accidental damage caused by defective or leaking batteries !
▶
Always store your products with the batteries removed!
▶
Store the product and the batteries in a cool and dry place. Comply with the temperature limits stated in
the technical data.
▶
Do not store batteries on the charger. Always remove the battery from the charger when the charging
operation has completed.
▶
Never leave batteries in direct sunlight, on sources of heat, or behind glass.
▶
Store the product and batteries where they cannot be accessed by children or unauthorized persons.
▶
Prior to each use and before and after prolonged storage, check the product and the batteries for
damage.
9 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to rectify the problem by
yourself, please contact Hilti Service.
If a problem occurs, always observe the charge-status and fault indicator of the battery.
→ See the section headed Status indicators of the Li­ion battery .
Trouble or fault Possible cause Action to be taken
Cut-off saw does not run. The batteries are not charged.
▶
Charge the battery.
Battery not fully inserted.
▶
Check that all batteries are
correctly inserted and engaged.
High vibration, wheel wanders
off the cutting line.
The cut-off wheel is not correctly
fitted and tightened.
▶
Check how it is fitted and the
tightening torque.
Cut-off wheel is damaged (or un-
suitable specification, cracked,
segments missing, bent, over-
heated, deformed, etc.).
▶
Change the cut-off wheel.
The centering bushing is fitted in-
correctly.
▶
Check that the diameter of the
arbor hole in the cut-off wheel
matches the centering collar
of the cut-off wheel centering
bushing.
Insufficient or no flow of wa-
ter.
Water nozzles are blocked.
▶
Clean the water nozzles.