English
19
Status
Meaning
One LED blinks green.
• Charge status is below 10 %. The fastening tool
is ready for operation.
One LED blinks green.
• The fastening tool is overloaded or overheated
and thus not ready for operation.
4 Technical data
4.1 Fastening tool
Weight (empty)
3.9 kg
Application temperature, ambient temperature
−10 ℃ …45 ℃
Maximum fastener length
39 mm
Fastener diameter
• 2.6 mm
• 3.0 mm
Compression stroke
20 mm
Magazine capacity in strips of 10 nails (Magazine capac-
ity)
1 …4
Maximum fastener driving frequency (Fasteners per hour)
1,200
Maximum magnetic field strength
−7.6 dBµA/m
Frequency
13,553 MHz …13,567 MHz
4.2 Noise information and vibration values
The sound pressure and vibration values given in these instructions have been measured in accordance
with a standardized test and may be used to compare one fastening tool with another. They may be used
for a preliminary assessment of exposure. The data given represents the main applications of the fastening
tool. However, if the fastening tool is used for different applications, with different accessories or is poorly
maintained, the data may vary. This may significantly increase exposure over the total working period. An
estimation of the level of exposure should also take into account the periods of time when the tool is not
actually in use. This may significantly reduce exposure over the total working period. Prescribe additional
safety measures to protect the operator from the effects of noise and/or vibration, such as: maintenance of
the direct fastening tool and its additional equipment or accessories, keeping the hands warm, organization
of work patterns.
Noise emission values determined in accordance with EN 15895
Emission sound pressure level at the workplace
(L
pA, 1s
)
96 dB(A)
Peak sound pressure level at the workplace (L
pC, peak
)
130 dB (C)
Sound (power) level (L
WA, 1s
)
100 dB(A)
Sound level uncertainty
2 dB(A) / 2 dB(C)
Recoil
Energy-equivalent acceleration, (a
hw, RMS(3)
)
Results for 1 mm sheet metal on C40 con-
crete: 3.69 m/s
2
Uncertainty
0.22 m/s²
5 Loading the fastening tool
5.1 Equipment required for driving nails
Nails are fed through the magazine in strip form (ready-to-use strips of nails).
5.2 Loading the magazine
1. Pull the nail pusher back until it engages.
Printed: 11.09.2017 | Doc-Nr: PUB / 5336064 / 000 / 02
