Hilti GTB 6X-22, Manual

Page: 15 / 60

*2332219*
2332219 English 9
Comply with the national regulations for working at heights.
As drop arrester for this product, use only a combination of the Hilti retaining strap and the Hilti tool tether
#2261970.
▶
Secure the retaining strap to the installation openings for accessories. Check that it holds securely.
▶
Secure one carabiner of the tool tether to the retaining strap and secure the second carabiner to a
load-bearing structure. Check that both carabiners hold securely.
Comply with the operating instructions of the Hilti retaining strap and those of the Hilti tool tether.
6 Operation
Observe the safety instructions and warnings in this documentation and on the product.
6.1 Switching on
1. Press the rear section of the on/off switch.
2. Slide the on/off switch forward.
▶
The motor runs.
3. Lock the on/off switch.
6.2 Setting belt speed
▶
Use the adjusting knob to set the belt speed.
Stages of belt speed
Stage 1 3.8 m/s
(12.5 ft/s)
Stage 2 4.6 m/s
(15.1 ft/s)
Stage 3 5.4 m/s
(17.7 ft/s)
Stage 4 6.2 m/s
(20.3 ft/s)
Stage 5 7.2 m/s
(23.6 ft/s)
Stage 6 8.4 m/s
(27.6 ft/s)
6.3 Grinding 4
CAUTION
Risk of injury! Touching a moving abrasive belt can lead to painful skin abrasion and cut injuries.
▶
Do not touch the moving abrasive belt.
CAUTION
Risk of injury! Grinding makes the workpiece hot.
▶
Do not attempt to touch the workpiece immediately after grinding and always wear suitable protective
gloves to prevent burns. Keep everyone clear of your work zone.
Before grinding, always check that the abrasive belt is centered on and in full contact with the rollers.
Never force the abrasive belt at an angle to the direction of travel.
1. Lift the pipe belt grinder clear of the work surface.