Hilti DSW 2005-TS, Manual

Page: 10 / 44

6 English 2235115
*2235115*
▶
Keep children and other persons away from the working area.
▶
Avoid awkward postures. Maintain firm footing and balance at all times.
▶
Use only approved fasteners and lifting equipment of adequate load-bearing capacity
to secure, lift clear and transport from site the parts of the structure that are cut away.
▶
Always run cables and hoses flat on the floor or ground away from the product to
prevent trip hazards.
▶
Keep cables and hoses away from rotating parts.
▶
Jointly with site management, make sure that no gas, water, electricity or other lines
are located in the cutting area. Lines in the vicinity of the cutting zone that could
be damaged by falling parts, for example, have to be specially protected and, if
necessary, temporarily taken out of service.
▶
Ensure that the cooling water used is drained or extracted in a suitably controlled
manner. Cooling water allowed to drain away or spray around in an uncontrolled
manner can lead to damage and accidents. Also bear in mind that water can drain
away through hidden internal cavities.
2.3 General safety rules
▶
Use the product only after you have read the operating instructions, after becoming
familiar with the content of the instructions and after receiving training by a Hilti
specialist. Observe all warnings and instructions.
▶
Use the right product for the job. Do not use the product for purposes for which it was
not intended. Use it only as directed and when in faultless condition.
▶
Use the product and its accessories, accessory tools, etc. in accordance with these
instructions and in the manner intended for the particular type of product. Take the
working conditions and the work to be performed into account. Use of this product
for uses other than those intended could result in hazardous situations.
▶
Take influences of the surrounding area into account. Do not use the product where
there is a risk of fire and explosion. Power tools create sparks which can ignite dust
or gases.
▶
Keep the grips clean, dry and free from oil and grease.
▶
Do not overload your product. It will work more efficiently and more safely within its
intended performance range.
▶
Never leave the product unattended.
▶
Store the product in a secure place when not in use. When not in use, products must
be stored in a dry, high place or locked away, out of reach of children.
▶
Always disconnect the supply cord from the electricity supply when the product is
not in use (e.g. during breaks between working), before changing settings, before
cleaning and maintenance and before changing tools. This safety precaution prevents
the product from starting accidentally.
▶
Remove adjusting tools or wrenches before switching on the product. A tool or a
wrench left attached to a rotating part of the product can cause injury.
▶
Before use, the product, the sawing wire and accessories must be checked carefully
to ensure that all items function faultlessly and as intended. Check that moving parts
function faultlessly, without sticking, and that no parts are damaged. All parts must be
fitted correctly and fulfill all conditions necessary for correct operation of the product.
Damaged parts must be repaired or replaced properly by an authorized service center.
▶
Avoid skin contact with drilling and sawing slurry.
▶
Follow the instructions concerning care and maintenance.
▶
The product is not intended for use by children, by debilitated persons or by persons
who have received no instruction or training.