Hilti DSW 1510-CA, Manual

Page: 29 / 48

*2238935*
2238935 English 25
1. Set up the drive unit on the jobsite. → page 23
2. Connect a cooling-water hose to the inlet on the drive unit and to an outlet of the
on-site water supply.
3. Connect both cooling-water hoses to distributors (A) and (B) .
4. Route the cooling-water hoses to the cutting location and connect the cooling water
hoses to the flexible cooling-water spray nozzles.
5. Open the water valves at the distributors.
6. Open the on-site water supply.
Water can flow through, because the main switch is set to OFF .
7. Position the compressor in the vicinity of the drive unit.
▶
The compressor is positioned where it cannot get wet.
8. Connect the compressed-air hose to the compressor and to the drive unit.
9. Establish an electricity supply and switch the compressor on.
▶
Comply with the instructions for use in the operating instructions of the compressor
(max. 10 bar).
10.Remove the guard from the electricity connector by turning the locking sleeve counter-
clockwise to disengage it.
11.Using a suitable power cord, connect the drive unit to the power source.
7.2 Pairing DST WRC-CA wireless remote control
The drive unit has to be connected to the electricity supply in order for it to be
paired to the DST WRC-CA wireless remote control.
1. Remove the protective cap from the connector on the drive unit.
2. Plug the remote control back up cable into the socket and tighten the securing sleeve.
▶
An audible click confirms correct latching.
3. Plug the remote control back up cable into the socket of the wireless remote control.
4. Set the main power switch of the drive unit to ON .
5. Set the main power switch on the remote control to ON .
6. Follow the installation instructions displayed on the screen.
7. Refer to the corresponding chapter wire saw mode in the operating instructions
DST WRC-CA remote control.