*2153083*
2153083
English
13
5.6 Preparing the floor saw for use
1. Bring the blade guard holder into the 12 o'clock position (see operating instructions
for the electric wall saw).
2. Fit the saw blade (see operating instructions for the electric wall saw).
Technical data
Saw blade diameter (when using the
DSF 1030TS trolley)
600 mm … 800 mm
3. Fit the blade guard (see operating instructions for the electric wall saw).
Technical data
Suitable blade guard types
•
DSBG65
saw blade guard
•
DSTBG80
saw blade guard
4. Make sure that the water supply system supplied with the floor saw trolley is mounted
on the blade guard.
5. Connect the water hose to the water supply system connector and secure the hose to
the hose attachment points on the handlebar of the floor saw trolley.
6. Fit the remote control unit onto the attachment points on the handlebar of the floor
saw trolley and, if not already done, connect the control cable between the remote
control unit and the saw head.
7. Plug the supply cord for the saw into the electric supply (see operating instructions
for the electric wall saw) and secure the supply cord to the attachment points on the
handlebar of the floor saw trolley.
6
Operation
6.1 Engaging / disengaging the floor saw trolley traction drive
6.1.1 Engaging the traction drive (saw advance).
1. Place your foot on the freewheel lever and press it down.
2. Push the freewheel lever to the right, as far as it will go. If necessary, move the trolley
back or forward slightly by hand in order to help the clutch gear wheels mesh together
and engage.
6.1.2 Disengaging the traction drive (saw advance).
1. Position your foot at the right-hand side of the freewheel lever and push the freewheel
lever to the left, as far as it will go.
2. Take your foot away from the freewheel lever.
➥ The freewheel lever moves upwards under spring pressure and remains engaged
in this position in the cut-out in the trolley frame.
6.2 Making a cut
1. Switch on the remote control unit for the saw (see the operating instructions for the
remote control unit).
2. Turn on the water supply and use the water regulating valve to adjust the water flow
rate as desired.
3. Position yourself behind the handlebar and start the saw.
4. Lower the saw blade and begin the guide cut by allowing the blade to cut into the
floor to a depth of 3 to 5 cm.
Printed: 07.05.2019 | Doc-Nr: PUB / 5492449 / 000 / 00
Summary of Contents for DSF 1030-TS
