Hilti DD 160, Manual

Page: 38 / 592

32 English 434951
*434951*
5.9 Fitting a diamond core bit in a BI+ chuck 9
CAUTION
Risk of injury when changing the tool! The tool becomes hot as a result of use. It may have sharp edges.
▶ Always wear protective gloves when changing the tool.
Diamond core bits must be replaced when the cutting performance and/or rate of drilling progress
drops significantly. Generally, this is the case when the segments have worn down to a certain height.
1. Lock the carriage on the rail with the carriage lock. Check to ensure that it is securely fastened.
2. Open the chuck by turning it in the direction of the "Open brackets" symbol.
3. From below, push the diamond core bit into the chuck on the diamond core drilling machine, turning it
until the teeth engage.
4. Close the chuck by turning it in the direction of the "Closed brackets" symbol.
5. Check that the diamond core bit is seated securely in the chuck.
5.10 Selecting the speed 10
CAUTION
Risk of wear and tear Risk of damage to the gearing
▶ Do not attempt to change gear while the machine is running. Wait until the arbor comes to a complete
stop.
▶ While using one hand to turn the core bit, set the switch to the recommended setting.
5.11 Removing a diamond core bit from a BI+ chuck
CAUTION
Risk of injury when changing the tool! The tool becomes hot as a result of use. It may have sharp edges.
▶ Always wear protective gloves when changing the tool.
1. Lock the carriage on the rail with the carriage lock. Check to ensure that it is securely fastened.
2. Open the chuck by turning it in the direction of the "Open brackets" symbol.
3. Pull the sleeve on the chuck in the direction of the arrow towards the machine. This releases the core bit.
4. Remove the core bit.
6 Operation
6.1 Enabling a diamond core drilling machine with (optional) theft protection system (TPS)
The "Theft Protection System" function (TPS) is an option for the DD 160 diamond core drilling machine. If
equipped with this feature, the diamond core drilling machine can be unlocked and readied for operation
only through use of the corresponding TPS key.
Further detailed information on activation and use of the theft protection system can be found in the
operating instructions for the TPS theft protection system.
1. Plug the supply cord of the diamond core drilling machine into the power outlet.
2. Press the "
I " or " RESET " button on the portable residual current device (PRCD).
➥ The yellow theft protection indicator LED flashes.
3. Hold the TPS key directly against the lock symbol.
➥ The yellow theft protection indicator LED goes out and the machine is enabled.
If the power supply is interrupted, the diamond core drilling machine remains ready for operation
for approximately 20 minutes. If the interruption is longer, the theft protection system has to be
deactivated again with the TPS key.
Printed: 09.08.2019 | Doc-Nr: PUB / 5069586 / 000 / 08