hilscher NIOT-E-TPI51-EN-RE, User Manual, Page: 10 / 258

Connectors and mounting 10/258
4 Connectors and mounting
4.1 Mounting
Mount the Edge Gateway on a DIN rail onto the wall of the cabinet.
4.2 Power supply
DC 24V Pin Signal Description
- GND Ground (Reference potential)
+ +24 V DC +24 V DC
FE Functional earth
Table 3: Power supply connector
4.3 LAN connectors
The Edge Gateway has one LAN connector for connecting it to the cloud
network (IT network), position
(8) (see section Positions of the
interfaces [
}
page 8]).
The MAC addresses of the LAN interfaces are printed on the device label.
Section Configuring Ethernet communication (LAN) [ } page 51] describes,
how you can set the IP address parameters of the LAN interfaces.
4.4 Real-Time Ethernet connectors
The Edge Gateway has 2 RJ45-connectors to connect the fieldbus to a
Real-Time Ethernet network (OT network), positions
(9) and (10) (see
section Positions of the interfaces [ } page 8]).
For data exchange at the fieldbus, use the fieldbus input and output in node
Node-RED. Sections
Example 6: Fieldbus input node [
}
page 135] and
Example 7: Fieldbus output node [
}
page 143] describe how to access the
cyclic I/O data of the fieldbus in Node-RED.
4.5 USB connectors
The Edge Gateway has 4 USB connectors (4 x USB 2.0), positions (2) and
(7) (see section Positions of the interfaces [
}
page 8]).
Edge Gateway | NIOT-E-TPI51-EN-RE (Connect)
DOC170502UM04EN | Revision 4 | English | 2018-08 | Released | Public © Hilscher 2017 – 2018