Package, Pinning, Pad Cells
33/56
netX 50 to netX 51/52 | Migration Guide
DOC120109MG05EN | Revision 5 | English | 2013-08 | Released | Public
2012-2013
Function
Signal Type
Functional Group
nx50
nx51/52
PIO0...7 In/out
PIO
X X
SPI0_CS2N In/out
SPI0
X X
SPI1_CLK In/out
SPI1
X X
SPI1_CS0N In/out
SPI1
X X
SPI1_CS1N In/out
SPI1
X X
SPI1_CS2N In/out
SPI1
X X
SPI1_MISO In/out
SPI1
X X
SPI1_MOSI In/out
SPI1
X X
I2C0_SCL In/out
I2C0
X X
I2C0_SDA In/out
I2C0
X X
I2C1_SCL In/out
I2C1
- X
I2C1_SDA In/out
I2C1
- X
XC_SAMPLE0 Input
Trigger/Latch Unit
X X
XC_SAMPLE1 Input
Trigger/Latch Unit
X X
XC_TRIGGER0
Tristate able output
Trigger/Latch Unit
X X
XC_TRIGGER1
Tristate able output
Trigger/Latch Unit
X X
UART0...2_CTSN Input
UART
0...2
X X
UART0...2_RTSN
Tristate able output
UART 0...2
X X
UART0...2_RXD Input
UART
0...2
X X
UART0...2_TXD
Tristate able output
UART 0...2
X X
USB_ID_DIG Input
USB
X -
USB_ID_PULLUP_CTRL
Non-tristate able output
USB
X -
USB_RPD_ENA
Non-tristate able output
USB
X -
USB_RPU_ENA
Non-tristate able output
USB
X -
CCD_DATA0...7 Input
CCD-Sensor
X -
CCD_PIXCLK Input
CCD-Sensor
X -
CCD_LINE_VALID Input
CCD-Sensor
X -
CCD_FRAME_VALID Input
CCD-Sensor
X -
CAN_RX Input
CAN
- X
CAN_TX Always
driven
output
CAN
- X
MEM_RDY
Input
MEM IF ready/busy input
- X
Table 17: Multiplex-Matrix Signals
The internal functions which can be mapped at the MMIO signals change as following:
The internal CCD Controller is not implemented anymore
The internal MII signals for the internal PHYs can not be mapped anymore
A second I2C controller is implemented special for accessing the fiber optic transceiver in
PROFINET communication
The additional USB signals are no more necessary because netX 50 has only s USB device
and the USB pin becomes a function to pull the USB line high.
The signals of the dedicated CAN controller are also available at the MMIO pins.
