Description and Requirements
22/86
netTAP NT 50 | Gateway Devices
DOC091202UM09EN | Revision 9 | English | 2013-02 | Released | Public
© Hilscher, 2010-2013
3.3 System
Requirements
The netTAP NT 50 device must be mounted on a DIN-rail according to DIN
EN 60715.
A suitable power supply is required. The voltage to be applied must be in
the allowed range 24 V ± 6 V DC. The power supply must be able to deliver
at least a current of 100 mA at 24 V.
Power supply is possible via pins 1 (GND) and 2 (24V) of the netTAP NT
50 power supply connector located on the upper side of the device.
Device Destruction!
!
The voltage must not exceed 30 V significantly, otherwise the device
may be destroyed or damaged.
In order to avoid damage caused by overheating or freezing, it is necessary
that the temperature of the device does not exceed the limits of the allowed
temperature range.
The following preconditions must additionally be met in order to operate the
Gateway device successfully:
1. The Gateway device must have been provided with the correctly suiting
firmware.
2. The Gateway device must have been configured correctly using the
SYCON.net configuration software.
3.4 Configuration
Requirements
The configuration software SYCON.net must be installed on a PC. The re-
quirements for the PC are:
•
PC with 1 GHz processor or higher
•
Windows
®
XP SP3, Windows
®
Vista (32 bit) SP2, Windows
®
7 (32 bit) or
Windows
®
7 (64 bit)
•
Administrator rights
•
Internet Explorer 5.5 or higher
•
Free disk space: min. 400 MByte
•
DVD ROM drive
•
RAM: min. 512 MByte, recommended 1024 MByte
•
Graphic resolution: min. 1024 x 768 pixel
•
Keyboard and Mouse
•
USB
Note:
If the project file is saved and opened again or it is used on another
PC, the system requirements need to match. Particularly the DTMs need
to be installed on the used PC.
