Technical Data
143/223
PC Cards cifX PCI, PCIe, Low Profile PCIe | Installation, Operation and Hardware Description
DOC120204UM46EN | Revision 46 | English | 2015-12 | Relelased | Public
© Hilscher, 2008-2015
CIFX 50E-2ASM
Parameter
Value
Configuration Configuration Software
SYCON.net
Table 112: Technical Data CIFX 50E-2ASM
10.1.19 CIFX 70E-RE, CIFX 70E-RE\MR
CIFX 70E-RE,
CIFX 70E-RE\MR
Parameter
Value
Name
CIFX 70E-RE
CIFX 70E-RE\MR
Part No.
1.259.100
1.259.103
Description
PC Card cifX Low Profile PCI Express Real-Time-Ethernet
Master or Slave (Low Profile PCIe with RTE), (and
variants with additional MRAM ‚MR’)
Part
Function
Communication interface with PCI Express and
Ethernet interface
Communication
Controller
Type netX
100
processor
RAM
8 MB SDRAM
FLASH
4 MB serial Flash EPROM
Size of the Dual-Port Memory
64 KByte
Integrated Memory
MRAM (only CIFX 70E-RE\MR)
128Kbyte (= 64K Words);
Note:
Using the cifX Device Driver (from Version 1.1.1.0)
access to this memory is possible and it can be used as a
remanent memory.
Bus Type
PCI Express, One Lane Port, according to [bus spec 2,
Rev. 2.0] and [bus spec 3], refer to section
Overview
,
page 114.
Transmission Rate
2 GBit/s
Data Access
DPM or DMA (Direct Memory Access)
System Interface
Width for the data access to the
Dual-Port Memory (DPM)
32-Bit
EtherCAT Master, EtherCAT Slave
EtherNet/IP Scanner (Master),
EtherNet/IP Adapter (Slave),
Open Modbus/TCP
POWERLINK Controlled Node/Slave
PROFINET IO-Controller (Master),
PROFINET IO-Device (Slave)
sercos Master, sercos Slave
Supported Real-Time Ethernet
communication systems
(determined by the loaded
firmware)
VARAN Client (Slave)
Ethernet
Communication
Ethernet Frame Types
Ethernet II
Transmission rate
100 MBit/s,
10 MBit/s (depending on loaded firmware)
Interface Type
100 BASE-TX,
10 BASE-T (depending on loaded firmware),
refer to section
Ethernet Interface
, page 105.
Galvanic Isolation
isolated
Isolation Voltage
1000 VDC (tested for 1 minute)
Half duplex/Full duplex
depending on loaded firmware,
supported (at 100 MBit/s)
Auto-Negotiation
depending on loaded firmware
Auto-Crossover
depending on loaded firmware
Ethernet Interface
Connector
2* RJ45 Socket
