Mounting and demounting
17/146
6
Mounting and demounting
6.1
Mounting
Required tools for mounting the device
You will need the following tools for mounting:
·
Allen key for the M4 mounting screws with hexagon socket
Only additionally required for mounting without existing mounting holes:
·
M4 thread tap (ready-made or set of taps)
·
Drilling machine (to pre-drill the mounting holes as M4 threads for
mounting the device to the system)
You will also need two M4 hexagon cylinder head screws according to DIN
912 / ISO 4762 of suitable length.
Before mounting the device
Always observe the following instructions:
·
The device may only be mounted and commissioned by qualified
electricians in accordance with EN 50110-1/-2 and IEC 60364.
·
Refer to the safety instructions in the
·
Before mounting the device, check for damage, e.g. transport damage!
Damaged devices must not be put into operation.
Mounting instructions
Observe the following points when selecting the mounting location:
·
When mounting outside buildings: Mount the device in such a way that
it is protected from weathering, especially from direct sunlight and the
effects of UV light, salt water or salt spray, e.g. in a switch box.
·
Only screw the device on flat contact surfaces to protect it from
mechanical tension.
·
Do not bridge any gaps with the device to protect it from any tensile
forces that may occur.
·
To prevent damage to the device, do not mount it in shearing areas of
moving system parts. Also, lay the cables in such a way that they
cannot be caught in the shear zones of moving system parts.
·
Leave sufficient space for easy replacement of the device and for
connecting the plug connections.
·
Ensure that the requirements of the device for vibration and shock
resistance are met at the mounting site.
·
Mount the device so that the diagnostic LEDs of the device remain
visible.
NFD-3090-PNS-IOLM\W | Hardware, installation and commissioning
DOC201101UM03EN | Revision 3 | English | 2022-02 | Released | Public
© Hilscher 2020 - 2022
