47
Chapter 3 Installation
|
Hillstone
Hillstone SG-6000 X-Series Hardware Reference Guide
3.
Identify the slot of IOM.
4.
If the slot is covered with a blank plate, loose its screws with a cross
screwdriver and remove the plate, see
5.
Position the IOM so that its front side faces you. Make sure that the lever is on
the left side and the IOM module is plain with the outside edge of the expansion
slot. Rotate the levers to outside, and slide the expansion module straight into
the slot along the guide rail.
Figure 3-9: Installing an IOM
6.
When the lever head is inserted into the expansion slot, you should rotate the
levers to the front of the module and slide the IOM into the slot until you feel
resistant.
7.
Tighten the screws on the IOM with a cross screwdriver.
8.
To install more IOMs, repeat Step 3 to 7
Installing Expansion Modules of SG-6000-X7180
The device
requires at least one SCM, one SSM and one IOM. Additional expansion
modules are added according to your needs.
This part includes the following sections:
Tools required
