Part 3 - Configuration
46
Advanced Setup
Configure security and other advanced camera settings.
•
Video
: Adjust the camera image sensor settings such
as white balance and exposure. Configuration options
may differ depending on the camera model.
•
Privacy Masking
: Enable/disable and configure
privacy masking for the camera.
•
PTZ
: If using an RS485-compliant camera, configure it
for use in PTZ Mode.
•
SSL
: Set the camera's security level as
Unavailable
,
Standard
,
High
, or
Very High
.
Standard
,
High
and
Very High
settings apply SSL (Secure Sockets Layer)
protection to the camera.
•
Reset
: Resets the port or cameras.
- PoE Reset: Control the PoE Switch’s port. This option
is available when connecting to Video In/PoE port
or using a DirectIP™ PoE Switch (optional). Select
PoE Reset
to reboot the camera. It is not supported
by video encoders.
- Soft Reset: Reboots the camera.
- Factory Reset: Resets the NVR to all its initial factory
settings. It is supported by DirectIP™ cameras only.
•
Mode:
Select a resolution mode. This is supported by
video encoders only.
PTZ Settings
–
PTZ Product
: Choose to select the model of
installed PTZ device.
–
ID
: Choose to assign an ID to each PTZ device.
– Choose to set up
Baud Rate
,
Data Bit
,
Stop Bit
and
Parity
of the connected device.
Refer to the PTZ device manufacturer’s instructions for
the proper settings.
Types of configuration options shown vary depending
on the PTZ functions supported by the camera.
1
2
3
4
5
6
7
8
9
0
!
Numbers shown below Preset, Scan, Pattern, and Tour
indicate the numbers of configured functions.
1
Preset
•
Use the buttons below to choose a preset position.
- Directional Buttons
(
):
Used to tilt and pan the camera.
-
Zoom
(
): Zoom in and out.
-
Focus
(
): Adjust camera focus to far or near.
-
Speed
: Specify the camera's panning and tilting
speed.
•
Set
: Choose a preset number and then enter a name.
This saves the current preset under the specified
preset number and name.
•
Go to
: Select a preset from the list and then click Go
to to move the camera to the selected preset position.
•
Edit
: Used to change the selected preset's name.
•
Remove
: Used to remove the selected preset.
