Hill-Rom VersaCare P3200, Service Manual

Page: 44 / 379

Function Checks
Chapter 2: Troubleshooting Procedures
Treatment Surface Function Check
1. Press the Max-inflate control on the intermediate siderail. After 30
seconds, wipe your hand across the mattress.
Verify that the three zones are inflated to a high pressure.
Yes No
↓ →
Go to RAP 2.24.
2. Press the Pressure Relief mode.
The Pressure Relief mode is active.
Yes No
↓ →
Go to RAP 2.24.
3. Articulate the patient surface to the flat position. The three zones are
inflated: head, seat, and foot.
Are the three zones inflated.
Yes No
↓ →
Go to RAP 2.24.
4. Squeeze and hold pressure on the head section.
The head section deflates slightly within 30 seconds.
Yes No
↓ →
Go to RAP 2.24.
5. Release the pressure in the head section.
The applicable head section inflates slightly within 30 seconds.
Yes No
↓ →
Go to RAP 2.24.
6. Articulate the head section to 65°. After 30 seconds, wipe your hand firmly
across the air mattress to verify that the head, seat, and foot zones are
inflated.
The head zone section has a lower (softer) pressure than the seat zone.
Yes No
↓ →
Go to RAP 2.24.
7. Make sure the head section is flat, place all four siderails in the up and
locked position. Activate the Right Turn Assist control.
Page 2 - 10 VersaCare™ Bed Service Manual (MAN333 REV 2)