Hill-Rom VersaCare P3200, Service Manual

Page: 148 / 379

4.5 Intermediate Siderail
Chapter 4: Removal, Replacement, and Adjustment Procedures
4.5 Intermediate Siderail
Tools required: Screwdriver
E-ring installation tool
Rubber mallet
Removal
1. Set the brakes.
2. Raise the bed to the high position.
3. Raise the knee section to the highest position.
4. Raise the siderail being changed to the up and locked position.
SHOCK HAZARD:
Unplug the bed from its power source. Failure to do so could result in
personal injury or equipment damage.
5. Unplug the bed from its power source.
6. Remove the E-ring (A) and washer (B) from the siderail dampener (C) (see
figure 4-8 on page 4-17).
7. Disconnect the dampener (C) from the mounting post (D).
8. Remove the head end E-ring (E) from the lower D-pin (F).
9. Remove the head end E-ring (G) from the upper D-pin (H).
10. Unlatch the siderail.
11. Remove the lower D-pin (F).
12. While supporting the siderail, remove the upper D-pin (H).
NOTE:
The right side D-pin bushing will come off the D-pin.
Page 4 - 16 VersaCare™ Bed Service Manual (MAN333 REV 2)