Hill-Rom TotalCare P1830A, Service Manual, Page: 42 / 92

4.3 Intermediate Siderail
Chapter 4: Removal, Replacement, and Adjustment Procedures
Page 4 - 10 TotalCare® Bariatric Bed Service Manual (man299ra)
4.3 Intermediate Siderail
Tools required: T25 Torx®
1
head screwdriver
Hi-Lo cylinder brace (P/N SA1695)
Small screwdriver
Removal
1. Set the brake on the bed.
2. Raise the bed to its highest position.
SHOCK HAZARD:
Unplug the unit from its power source. Failure to do so could result in
personal injury or equipment damage.
3. Unplug the bed from its power source.
SHOCK HAZARD:
Disable the battery. Failure to do so could result in personal injury or
equipment damage.
4. Disable the battery.
NOTE:
Disconnect the intermediate siderail cabling from the wiring harness. The
intermediate siderail cable should remain with the removed siderail.
5. Disconnect the intermediate siderail cabling from the wiring harness as
follows:
a. Remove all the cable ties from the harness.
b. Disconnect the in-line harness connector at the weigh frame junction
electrical box (plug P10 left and plug P3 right).
6. Remove the two screws (A) from the deck mounting plate (B) (see figure
4-3 on page 4-11).
7. Remove the two screws (D) securing the siderail (C) to the bed.
8. Remove the siderail (C) and the wiring harness.
1. Torx® is a registered trademark of Textron, Inc.