Hill-Rom RESIDENT P872, Service Manual, Page: 60 / 178

2.6 Head Actuator Malfunction
Chapter 2: Troubleshooting Procedures
Page 2 - 30 RESIDENT® Low Bed Service Manual (man259)
Figure 2-12. Hand Pendant
You hear a click each time you press the head up (A) or head down (B)
button.
Yes No
↓ →
If a only one button produces a click when pushed, go to RAP
2.5. If there is no click when either button is pushed, replace the
electrical control/lockout box (refer to procedure 4.9). If this
solves the problem, go to “Final Actions” on page 2-16.
6. Press and hold the head up button (A) on the hand pendant.
The head and knee sections rise together until the knee section is at an
angle of approximately 15° (± 2°) and the head section is at an angle of
approximately 25° (± 2°). The knee section stops rising, but the head
section continues to rise until it is at an angle of approximately 65° (± 2°)
when it stops automatically.
Yes No
↓ →
Check for interference from other parts of the bed. If interference
is found, correct it. If no interference is found, replace the head
actuator (refer to procedure 4.12).
7. Press and hold the head down button (B) on the hand pendant.
m259_013