Hill-Rom RESIDENT P872, Service Manual, Page: 49 / 178

2.2 Central Braking Malfunction
Chapter 2: Troubleshooting Procedures
RESIDENT® Low Bed Service Manual (man259) Page 2 - 19
2
2.2 Central Braking Malfunction
1. Raise the foot end siderails, and press down on one of the brake pedals (A)
until it locks (see figure 2-8 on page 2-19).
Figure 2-8. Central Braking System
The brake pedal (A) moves with nominal resistance and locks into place.
Yes No
↓ →
Check that the Allen™
1
screw (B) is firmly engaged with the hex
rod (C) (refer to procedure 4.3). If this solves the problem, go to
“Final Actions” on page 2-16. If not, go to step 2.
2. Repeat step 1 with each of the other brake pedals (A).
The brake pedal (A) moves with nominal resistance and locks into place.
Yes No
↓ →
Check that the Allen™ screw (B) is firmly engaged with the hex
rod (C) (refer to procedure 4.3). If this solves the problem, go to
“Final Actions” on page 2-16. If not, go to step 3.
3. Perform the following:
1. Allen™ is a trademark of Industrial Fasteners, Inc.
m259_010