Hill-Rom RESIDENT P872, Service Manual, Page: 47 / 178

2.1 Floor Lock Brakes Malfunction
Chapter 2: Troubleshooting Procedures
RESIDENT® Low Bed Service Manual (man259) Page 2 - 17
2
2.1 Floor Lock Brakes Malfunction
1. The floor lock brake (A) is firmly attached to the base frame (B), and no
screws (C) are loose (see figure 2-7 on page 2-17).
Figure 2-7. Floor Lock Brakes and Casters
Yes No
↓ →
Remove any loose screws (C), apply blue Loctite®
1
adhesive
(P/N SA3618), and install the screws (C). If this solves the
problem, go to “Final Actions” on page 2-16. If not, go to step 2.
2. Raise the foot end siderail, and press down on the floor lock pedal (D).
The floor lock brake (A) moves down smoothly and raises the caster (E)
off the floor.
Yes No
↓ →
Replace the floor lock brake (A) (refer to procedure 4.1).
3. Use the unlocking lever (F) to release the floor lock brake (A).
The floor lock brake (A) releases easily and lowers smoothly to allow the
bed to rest on the caster (E).
1. Loctite® is a registered trademark of Loctite Corporation
m259_009