Hill-Rom RESIDENT P872, Service Manual, Page: 117 / 178

4.10 Junction Box
Chapter 4: Removal, Replacement, and Adjustment Procedures
RESIDENT® Low Bed Service Manual (man259) Page 4 - 29
4
4.10 Junction Box
Tools required: Phillips head screwdriver
Removal
1. Move the bed to a convenient working location.
WARNING:
Lock all caster brakes. Failure to do so could result in inadvertent
movement of the bed. This could cause equipment damage or personal
injury.
2. Raise the foot end siderails, and lock all caster brakes or floor lock brakes.
3. Flip the foot deck panel back onto the thigh and seat sections to gain access
to the underside electrical components.
WARNING:
The bed is always energized when plugged into a power source.
Unplug the unit from its power source. Failure to do so could result in
inadvertent movement of the bed and could cause personal injury.
4. Unplug the unit its power source.
5. Disconnect the junction box plug (A) from the electrical control/lockout
box (B) (see figure 4-12 on page 4-30).