Hill-Rom RESIDENT P872, Service Manual, Page: 73 / 178

2.9 Automatic Contour Malfunction
Chapter 2: Troubleshooting Procedures
RESIDENT® Low Bed Service Manual (man259) Page 2 - 43
2
Yes No
↓ →
Check for interference from other parts of the bed. If interference
is found, correct it. If no interference is found, refer to table 2-4
on page 2-43.
Table 2-4. Automatic Contour Troubleshooting Options
6. Press and hold the head down button (B) on the hand pendant.
The head section lowers smoothly until it is at an angle of approximately
25° (± 2) at which point the knee section begins to lower. The sections do
not stop lowering until they are flat.
Yes No
↓ →
Check for interference from other parts of the bed. If interference
is found, correct it. If no interference is found, refer to table 2-4
on page 2-43.
7. Raise the head section until the head section is at approximately 25° and
the knee section is at approximately 15°.
At the electrical control/lockout box (D), push in the head actuator lockout
button (J) (see figure 2-22 on page 2-44).
For this Non-Working Function Refer to this RAP
The head section does not move. Go to RAP 2.6.
The knee section does not move. Go to RAP 2.7.