Hill-Rom RESIDENT P872, Service Manual, Page: 40 / 178

Function Checks
Chapter 2: Troubleshooting Procedures
Page 2 - 10 RESIDENT® Low Bed Service Manual (man259)
The unit lowers smoothly until the platform is at 11½" (29.21 cm) above
the floor.
Yes No
↓ →
Go to RAP 2.8.
13. Press and hold the head up button (AB) on the hand pendant until the unit
stops by itself.
The head and knee sections rise simultaneously. The knee section stops
rising when it reaches an angle of approximately 15°, but the head section
continues to rise until it reaches an angle of 65° (± 2°).
Yes No
↓ →
Refer to table 2-3 on page 2-23, and take the appropriate action.
Table 2-2. Automatic Contour Troubleshooting Options
14. Press and hold the head down button (AC) on the hand pendant until the
unit stops by itself.
The head section begins to lower. When the head section reaches an angle
of approximately 25°, the knee section begins to lower. Both sections
lower smoothly until they are flat (parallel to the floor).
Yes No
↓ →
Refer to table 2-3 on page 2-23, and take the appropriate action.
15. Press and hold the knee up button (AD) on the hand pendant until the unit
stops by itself.
The head and knee sections rise simultaneously. The knee section stops
rising when it reaches an angle of approximately 15°, but the head section
continues to rise until it reaches an angle of 25°.
Yes No
↓ →
Go to RAP 2.9.
16. Press and hold the knee down button (AE) on the hand pendant until the
unit stops by itself.
The head and knee sections lower smoothly until they are flat (parallel to
the floor).
Yes No
↓ →
Go to RAP 2.9.
For this Non-Working Function Refer to this RAP
The head section fails to rise. Go to RAP 2.6.
The knee section fails to rise. Go to RAP 2.7.