Hill-Rom RESIDENT P872, Service Manual, Page: 131 / 178

4.15 Automatic Contour Assembly
Chapter 4: Removal, Replacement, and Adjustment Procedures
RESIDENT® Low Bed Service Manual (man259) Page 4 - 43
4
4.15 Automatic Contour Assembly
Tools required: Blue Loctite®
1
adhesive (P/N SA3618)
Phillips head screwdriver
7/16" Torx®
2
driver bit
Cable tie tool
Removal
1. Move the bed to a convenient working location.
WARNING:
Lock all caster brakes. Failure to do so could result in inadvertent
movement of the bed. This could cause equipment damage or personal
injury.
2. Raise the foot end siderails, and lock all caster brakes or floor lock brakes.
3. If possible, lower the bed to its lowest position.
WARNING:
The bed is always energized when plugged into a power source.
Unplug the unit from its power source. Failure to do so could result in
inadvertent movement of the bed and could cause personal injury.
4. Unplug the bed from its power source.
5. Remove any mattress from the unit.
6. Remove the two Torx® head screws (A) that secure the seat pan (B) to the
intermediate frame (see figure 4-17 on page 4-44).
1. Loctite® is a registered trademark of Loctite Corporation.
2. Torx® is a registered trademark of Textron, Inc.