Hill-Rom RESIDENT P872, Service Manual, Page: 128 / 178

4.14 Hilow Actuator
Chapter 4: Removal, Replacement, and Adjustment Procedures
Page 4 - 40 RESIDENT® Low Bed Service Manual (man259)
4.14 Hilow Actuator
Tools required: Screwdriver
Pliers
Cable tie tool
Removal
1. Move the bed to a convenient working location.
WARNING:
Lock all caster brakes. Failure to do so could result in inadvertent
movement of the bed. This could cause equipment damage or personal
injury.
2. Raise the foot end siderails, and lock all caster brakes or floor lock brakes.
3. If possible, lower the bed to its lowest position.
WARNING:
The bed is always energized when connected to a power source.
Unplug the bed from its power source before performing any service on
the bed. Failure to do so could result in inadvertent movement of the
bed and could cause personal injury.
4. Unplug the bed from its power source.
5. Remove any mattress from the unit.
6. Raise the head section to its highest elevation to provide easy access to the
hilow actuator.
7. Remove the hilow actuator plug (A) from the electrical control/lockout box
(B) (see figure 4-16 on page 4-41).