Hill-Rom RESIDENT P872, Service Manual, Page: 108 / 178

4.7 Sleep Surface Components
Chapter 4: Removal, Replacement, and Adjustment Procedures
Page 4 - 20 RESIDENT® Low Bed Service Manual (man259)
5. To remove the following parts, use the proper tools and techniques, and
remove any fasteners that connect them to other components or the
intermediate frame (A) (see figure 4-7 on page 4-21):
a. To remove the foot rack weldment (B), use the 9/16" open end wrench
to remove the two hex bolts (C) and washers (D) that secure it to the
intermediate frame (A).
b. To remove head section deck (E), remove the head actuator (refer to
procedure 4.12), and use the 9/16" open end wrench to remove the two
shoulder screws (F), two Oilite®
1
bushings (G), two washers (H), and
two locknuts (I) that secure it to the intermediate frame (A).
c. To remove the seat pan (J), remove the two Torx®
2
button head screws
(K) that secure it to the intermediate frame (A).
d. To remove the thigh section deck (L) and foot section deck (Q), remove
the knee actuator (refer to procedure 4.13), and use the 9/16" open end
wrench to remove the two shoulder screws (M), two Oilite® bushings
(N), two washers (O), and two locknuts (P) that secure it to the
intermediate frame (A).
e. To remove the foot section deck (Q) from the thigh section deck (L),
use the 9/16" open end wrench to remove the two shoulder screws (R),
two Oilite® bushings (S), two washers (T), and two locknuts (U) that
secure the foot section deck (Q) to the thigh section deck (L).
f. To remove the foot rack insert (V), remove the Torx® button head
screw (W) that secures it to the foot section deck (Q).
1. Oilite® is a registered trademark of Beemer Precision, Incorporated.
2. Torx® is a registered trademark of Textron, Inc.