Hill-Rom P870, Manual

Page: 135 / 231

4.8 Optional Siderail Control Panels
Chapter 4: Removal, Replacement, and Adjustment Procedures
Page 4 - 28 Resident
TM
LTC Bed Service Manual (man136rc)
4
Figure 4-22. Optional Siderail Control Panel—Right Hand Shown
5. Remove the two phillips head screws (H) securing the inboard housing (G)
and the two phillips head screws (B) securing the outboard housing (R) to
each other. Carefully separate the two housings. Do not drop either housing
to prevent damage to the installed printed circuit boards.
CAUTION:
Do not drop the printed circuit (P.C.) board against the siderail or the
sleep surface frame. Damage to the equipment may occur.
6. If the main cable (N) to the control lockout is being replaced:
a. Remove the two torx head screws (P) securing the wire cover (M) to
the siderail pivot arm (O). Remove the cover from the siderail.
b. Carefully remove the four phillips head screws (E). Separate the
head/knee P.C. board (F) from the inner housing(G).
A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
Q
R
m136_069