Hill-Rom P2016, Service Manual, Page: 54 / 133

4.3 Low Voltage Controller (P2016 Models Only)
Chapter 4: Removal, Replacement, and Adjustment Procedures
Page 4 - 6 Bed Locator Service Manual (man138ra)
4
4.3 Low Voltage Controller (P2016 Models Only)
Tools required: Adjustable wrench
Screwdriver
Digital multimeter
Removal
SHOCK HAZARD:
Locate the involved building standard or critical branch circuit breaker
panel. Set the involved circuit breaker to OFF. Lock out and tag out the
circuit breaker. Failure to follow this procedure could cause personal
injury or damage to the equipment.
1. Locate the involved building standard or critical branch circuit breaker
panel, and set the involved circuit breaker to OFF.
2. Lock out and tag out the circuit breaker.
3. Remove the bed locator access panel (refer to procedure 4.8).
4. Note the routing of the wiring.
5. Remove the three wire nuts (A) from the wire joints in the raceway that go
to the bed switches (see figure 4-2 on page 4-7).
6. Separate the three wire joints.
7. Remove the four wire nuts (B) from the wire joints on the high voltage side
of the controller.
8. Separate the four wire joints.
9. Using an adjustable wrench, remove the nut (C) from the ground stud (D),
and remove the two ground wires.
10. Remove the snap bushing (H) from the backplate assembly (I).
11. Using a screwdriver, remove the low voltage controller mounting screws
(F) and the low voltage controller (G) from the backplate assembly (I).