Hill-Rom® P500 Therapy Surface User Manual (158251 REV 3)
45
Controls Quick View
For more information about a control, go to the page number shown in
the table below.
Item
Control Description
Page
A
Normal—causes the air pressure in the surface sec-
tions to adjust according to the entered weight and
the surface head angle.
B
Max Inflate—causes the surface to become very firm
for 30 minutes.
C
Turn Assist—temporarily turns the occupant to the
left or right.
D
Confirm Rails Up—a reminder to make sure the sid-
erails are up for the Turn Assist mode. You must
press this control within two minutes before or after
you press the Turn Assist control.
E
Out of Bed Alarm—an alarm that monitors the pres-
ence of the occupant’s weight on the surface. If no
weight is detected, the system will go into an alarm
state.
F
Head Alarm—an alarm that monitors the angle of
the head section relative to the floor. If the angle is
less than 30°, the system will go into an alarm state.
G
RemindMe™ Settings—an alarm that can be turned
on as a reminder to do care tasks. You can set the
alarm to come on from 30 minutes up to 4 hours.
D
E
F
H
I
J
K
M
N
G
A
B
C
L
