Hill-Rom Century+ P1400, Service Manual, Page: 142 / 277

4.4 Battery Backup Cells
Chapter 4: Removal, Replacement, and Adjustment Procedures
™ Bed Service Manual (man241) Page 4 - 17
4
9. Label the battery cables (F), and disconnect the battery cables (F) from the
battery cells (D).
NOTE:
Be sure to label the battery cables before removing them from the battery cells.
10. Lift the battery cells (D) out of the battery box (C).
Replacement
1. If you are installing new batteries, attach the gaskets (E) to the battery cells
(D) by removing the adhesive-protecting paper and pressing the gaskets
(E) firmly onto the sides of the battery cells (D).
2. Install the battery cells (D) in the battery box (C).
3. Attach the battery cables (F) to the battery cells (D), being sure to make the
right connections.
4. Install the battery box cover (B) on the battery box (C), and using the T25
Torx® head screwdriver, secure it with the screws (A).
5. Connect the battery backup box by plugging the battery cable into the main
bed control board (see “Battery Backup Box” on page 4-8).
6. Install the control board box cover (see “Control Board” on page 4-5).
7. Untie the foot section of the sleep surface, and carefully lower it back
down.
8. If applicable, install the mattress on the bed.
9. Plug the bed into an appropriate power source.
WARNING:
Powered bed mechanisms can cause serious injury. Operate the bed
only with persons clear of mechanisms.
10. Test the bed functions to ensure they are working properly.
Adjustment
None