Hill-Rom CarePorter P3000, Service Manual

Page: 72 / 220

4.2 Printed Circuit Board Assembly (Motorized Shelf)
Chapter 4: Removal, Replacement, and Adjustment Procedures
CarePorter™ Cart Service Manual (man239) Page 4 - 9
4
Figure 4-2. Printed Circuit Board Assembly (Motorized Shelf)
6. Remove the shelf cover (B) from the CarePorter™ Cart (D).
7. Using the phillips head screwdriver, remove the four screws (E) that secure
the printed circuit board cover (F) to the shelf carriage weldment (C).
8. Remove the printed circuit board cover (F) from the CarePorter™ Cart (D).
CAUTION:
Ensure that all color-coded wires are marked to ensure proper
connection during the installation procedure. Failure to do so could
result in equipment damage.
9. Identify and disconnect the wiring connectors from the printed circuit
board (G).
10. Using the needle nose pliers, compress the standoffs (H), and remove the
printed circuit board (G).
m239_067